戻る
「早戻しボタン」を押すと検索画面に戻ります。 [閉じる]

コーパス検索結果 (1語後でソート)

通し番号をクリックするとPubMedの該当ページを表示します
1 ime enabled the full conversion of iodide to iodate.
2 t the chloride enhancement is not limited to iodate.
3 ion of iopamidol, and was mainly oxidized to iodate.
4 ironment may have prevented reduction of the iodate.
5  is often fortified with potassium iodide or iodate.
6 or after intraperitoneal injection of sodium iodate.
7 sponse to treatment with the oxidant, sodium iodate.
8 E) cells with a systemic injection of sodium iodate.
9 itted to intraperitoneal injection of sodium iodate (2% NaIO3, 50 mg/kg).
10 series of new alkali-metal or Tl(+) titanium iodates, A(2)Ti(IO(3))(6) (A = Li, Na, K, Rb, Cs, Tl).
11 ar calibration for iodine using a mixture of iodate and iodide ions was obtained from 10 to 100 ug L(
12 termined by combining the peak areas of both iodate and iodide ions.
13  method had a linear range 0.04-10 mg kg(-1) iodate and limit of detection of 4.4 ug kg(-1).
14 tive separation of two small inorganic ions, iodate and nitrate, is demonstrated on a reverse phase c
15 igation of POA decay and DBP (e.g., bromate, iodate, and iodophenol) generation in the POA/halide sys
16  yield HIO(3), which also contributes to the iodate anion signal.
17                 We estimate that ~50% of the iodate anion signals observed by nitrate CIMS under atmo
18 lar to those obtained by CIMS, including the iodate anion.
19                 This rotation allows for the iodate anions to bridge the molybdenum oxide chains in a
20 ordinate Bk(III) cations that are bridged by iodate anions to yield layers that are isomorphous with
21  molybdenum oxide chains that are bridged by iodate anions.
22 s, but results on (129)I species (iodide and iodate) are limited and only available for surface water
23 he results expose </=10% annual reduction of iodate as (129)I is transported from the English Channel
24  database entries to identify phosphates and iodates as the next generation of chemical spaces for st
25 od is presented that successfully determines iodate, chlorite, and bromate in drinking water at pract
26  Ag4(UO2)4(IO3)2(IO4)2O2 versus other uranyl iodate compounds with endotherms at 479 and 494 degrees
27                               Similarly, the iodate concentrations decrease as a function of time in
28                                Nevertheless, iodate concentrations decreased after a maximum was reac
29 red spectroscopy (DRS-FTIR) was employed for iodate determination in food grade salt and food product
30 e application of electrochemical methods for iodate determination was investigated using a bare scree
31                                              Iodate does not adsorb to the CuO surfaces used in this
32                                 After sodium iodate exposure, intraretinal manganese uptake was super
33 of nutrition and infection, use of potassium iodate for fortifying crude moist salt, research in the
34 of (129)I, while stable (127)I was mainly in iodate form, reflecting the fact that the major source o
35                The kinetics and the yield of iodate formation in natural waters depend mainly on the
36                              The kinetics of iodate formation is a critical factor in mitigation of t
37                     In this reaction system, iodate formation rates increase with increasing CuO (0-0
38 mide not only enhances the yield and rate of iodate formation, it also increases the formation of bro
39 alkaline permanganate for mineralization and iodate formation.
40 n also increased the conversion of iodide to iodate: from 45 to nearly 90% with a bromide concentrati
41 rticularly in higher iodine regions, whereas iodate impacts on thyroid risks in presence of universal
42 ficantly enhances the oxidation of iodide to iodate in a bromide-catalyzed process.
43 e quantifies 0.8-15 ppm of iodine atoms from iodate in aqueous solutions.
44 was developed for the on-site measurement of iodate in food-grade salt.
45  method was efficiently applied to determine iodate in table salt samples with percentage relative re
46 latform for electrochemical determination of iodate in table salt, offering potential as the basis fo
47 te in bottled water as well as low levels of iodate in tap water.
48 xidation reaction of tartrazine by potassium iodate in the acetate buffer medium.
49 unt of atmospherically nonrecyclable iodine (iodate) in marine aerosol.
50              Recoveries of spiked iodine (as iodate) in the samples were greater than 90%.
51 ging Pgam5(-/-) mice are resistant to sodium iodate-induced RPE cell death.
52        RPE damage was also induced by sodium iodate injection (40 mg/kg) into wild-type or albino C57
53  immobilization of aqueous iodide (I(-)) and iodate (IO(3)(-)) in the environment, but molecular inte
54 ly enriched in iodine, mostly in the form of iodate (IO(3)(-)) ions, compared to its relative abundan
55 organic (bromide (Br(-)), iodide (I(-)), and iodate (IO(3)(-))), organic, and total bromine (Br(T)) a
56                        The formation rate of iodate (IO3(-)) in the CuO-HOCl-I(-) system significantl
57 e of hypoiodous acid (HIO), iodite (IO2(-)), iodate (IO3(-)), triiodide (I3(-)), and molecular iodine
58                                Iodine, as an iodate ion or iodide ion, was simultaneously extracted a
59  of I(2)O(3) leads to the rapid formation of iodate ions (IO(3)(-)), which is the predominant soluble
60                                              Iodate ions produce a blue-black coloration on the PAD,
61 LLME), was proposed for the determination of iodate ions.
62                It could be demonstrated that iodate is oxidized to periodate by a CuO-activated hypoh
63                          Because particulate iodate is readily reduced, recycling iodine back into th
64 e in the concentration range of 10 to 100 mg iodate kg(-1) of salt, and a detection limit of 2.20 mg
65 mental data about the stability of potassium iodate (KIO(3)) or iodine uptake during food processing
66 /per one plant/one application) of potassium iodate (KIO(3)), salicylic acid (SA) alone or together w
67 alues for all samples, except when potassium iodate (KIO3) was used in the recipe.
68                         Three new molybdenyl iodates, KMoO3(IO3) (1), RbMoO3(IO3) (2), and CsMoO3(IO3
69 uranium oxide ribbons are joined by bridging iodate ligands to yield two-dimensional undulating sheet
70 ished and extensively characterized a sodium iodate (NaIO(3))-induced model of GA in pigmented Long E
71              Using an animal model of sodium iodate (NaIO(3))-induced RPE degeneration, BMCs were mob
72                   Distribution of iodide and iodate of both (127)I and (129)I in the Kattegat mainly
73 -arylimino-3H-indolizin-4-ium-1-olates by an iodate-promoted multicomponent reaction between 3,3-difl
74                        Our data suggest that iodate reduction to form volatile iodine species is a mi
75 dation of methane, ethane, and propane using iodate salts with catalytic amounts of chloride in proti
76                     The reduction process of iodate seems to be related to decomposition of organic m
77  A rapid, precise, and accurate amperometric iodate sensing strategy was established with this SPCE.
78                           We added potassium iodate to irrigation water over a 2 to 4 week period beg
79                                       Sodium iodate-treated rats exhibited an eightfold increase (P <
80 n urethane-anesthetized control rats, sodium iodate-treated rats, rats receiving intravitreally injec
81                              Furthermore, in iodate-treated rats, the average vitreous signal enhance
82  When RPE cells were compromised with sodium iodate, tumor cells or ovalbumin injected into the subre
83            The reaction of (249)Bk(OH)4 with iodate under hydrothermal conditions results in the form
84                                              Iodate was the dominant species and accounted for up to
85                                              Iodate was the main species incorporated into calcite an
86  correlated with the conversion of iodide to iodate, which increased from 10 to nearly 90%.
87 (3)(-) values suggest effective reduction of iodate with a maximum rate of 8 x 10(-7) ((127)IO(3)(-))
88  confirmed the electrocatalytic reduction of iodate, yielding a sensitivity of -0.596 muA/(mg/L).