戻る
「早戻しボタン」を押すと検索画面に戻ります。 [閉じる]

コーパス検索結果 (１語後でソート)

通し番号をクリックするとPubMedの該当ページを表示します
1  complementary metal-oxide semiconductor, or photomultiplier tube).
2 nging waveforms from an impedance mismatched photomultiplier tube.
3 d by a highly sensitive, large-dynamic-range photomultiplier tube.
4 e from tumor cells could be detected using a photomultiplier tube.
5  hollow fibers is detected using a miniature photomultiplier tube.
6 the flat-panel multianode position-sensitive photomultiplier tubes.
7 tection rate as compared to state-of-the-art photomultiplier tubes.
8 ar polarizations and collected onto separate photomultiplier tubes.
9 ly continuous light guide to an array of 420 photomultiplier tubes (39-mm diameter) in a hexagonal ar
10 al to be recorded in one pass using a single photomultiplier tube and eliminates the need for a polar
11  The ring-down signals are monitored using a photomultiplier tube and recorded using a digital oscill
12 ses magnetically shielded position-sensitive photomultiplier tubes and a compact 1-T permanent-magnet
13 th 0.5-mm pixels was coupled to multichannel photomultiplier tubes and evaluated for use as high-reso
14  iodide crystal, a 2 x 2 array of 53 x 53 mm photomultiplier tubes, and a parallel-hole collimator (1
15 has a high sensitivity because of the use of photomultiplier tube but also can get multiple-point dat
16 on crystals that are coupled to a 64-channel photomultiplier tube by optical fibers.
17       Because classic PET detectors based on photomultiplier tubes cannot be used in high magnetic fi
18                                     A single photomultiplier tube detects all the modulated emitted l
19 c control, (b) an integrated (and motorized) photomultiplier tube for chemiluminescent detection, and
20            The mass detection limits using a photomultiplier tube for sucrose and glucose are 50 ng,
21 g 488 and 635 nm lasers with two independent photomultiplier tubes for detection of the FITC and Cy5
22 sparent plastic flow cell placed between two photomultiplier tubes for radiometric detection.
23 e (GSO) crystals to 288 (36 x 8 array) 39-mm photomultiplier tubes in a hexagonal arrangement.
24 ctors such as single-photon avalanche diode, photomultiplier tube, or arrays of such detectors.
25  optimization, field of view, resolution and photomultiplier tube performance.
26        Measurement of UPE was carried out by photomultiplier tube (PMT) in the following steps: at th
27 ites, the ECL of luminol is followed using a photomultiplier tube (PMT) or digital camera and the ima
28 2) at the anodic poles was monitored using a photomultiplier tube (PMT) or digital camera.
29 2O2 at the anodic poles is monitored using a photomultiplier tube (PMT) or smartphone, and the images
30        Saturation is directly related to the photomultiplier tube (PMT) voltage settings and RNA abun
31 ed by measuring fluorescence over a range of photomultiplier tube (PMT) voltages by determining the P
32              This allows the use of a single photomultiplier tube (PMT), often the most expensive com
33               Compared with the conventional photomultiplier tube (PMT), the results revealed that th
34                                   Similarly, photomultiplier tubes (PMTs) can generate approximately
35 h significant portions of volume occupied by photomultiplier tubes (PMTs).
36 h the same crystal geometry but conventional photomultiplier tubes (PMTs).
37 parent screen directly on top of a miniature photomultiplier tube provides the basis of an attractive
38 ch) directly coupled to a position-sensitive photomultiplier tube (PS-PMT).
39 t chemiluminescent signal is quantified by a photomultiplier tube, recorded by a miniature onboard co
40 chondrial oxidation was detectable either by photomultiplier tube recordings of flavoprotein fluoresc
41 ne in a small reflective cell located atop a photomultiplier tube, resulting in intense CL.
42 ions avoiding the need for correction of the photomultiplier tube signal for the gating sequence.
43 n flow through a resin bed interfaced with a photomultiplier tube through a polycarbonate window.
44 s a common disk electrode, spectrometer, and photomultiplier tube to measure the O(ECL).
45 .75 mm each) coupled to a position-sensitive photomultiplier tube via an optical fiber bundle made of
46 e crystal arrays are coupled to multichannel photomultiplier tubes via a tapered, pixelated glass lig
47 n light is transmitted to position-sensitive photomultiplier tubes via optical light guides.
48      Conventional two-photon microscopes use photomultiplier tubes, which enable high sensitivity but
49 ons in aqueous media that can be detected by photomultiplier tubes with good sensitivity, without the