1 l-water mixture in the ultrapure water under
optimum condition.
2 udan I at a surface of propose sensor in the
optimum condition.
3 ion range (5-500muM) and current (muA) under
optimum conditions.
4 olar scales with a desirable stability under
optimum conditions.
5 NaBH(4) (in 0.2% NaOH) determined to be the
optimum conditions.
6 as used to model the data and to predict the
optimum conditions.
7 e analytical performance was evaluated under
optimum conditions.
8 hydrolyzed with papain and trypsin for 3h at
optimum conditions.
9 to develop the model and also to predict the
optimum conditions.
10 concentrations at the nanomolar level under
optimum conditions.
11 entrate, which was performed at the enzyme's
optimum conditions (
60 degrees C, pH 6.0) for 24 h.
12 Under the
optimum condition,
a linear calibration graph in the ran
13 Under the
optimum conditions,
a linear dependence of the guanine a
14 Under
optimum conditions,
a linear range of 50 muM to 10mM is
15 Under
optimum conditions,
a linear relationship between the di
16 However, with these
optimum conditions,
a second stimulation evoked more exo
17 Under
optimum condition,
amylose content of broken white rice
18 FMS, compatibility issues were addressed and
optimum conditions and procedures were identified and de
19 PJ was produced using the
optimum conditions and the quality characteristics such
20 ples were also produced separately under the
optimum conditions and their RS contents were 80.4% and
21 ability to accurately detect activity under
optimum conditions and with crude cell extract samples,
22 The
optimum conditions are obtained within a linear response
23 The predicted
optimum conditions are then used to carry out experiment
24 and others has simplified the selection of "
optimum" conditions,
but it is evident that many workers
25 Under
optimum conditions,
complete recovery of O2-evolving act
26 Under the
optimum conditions,
detection limits of 0.5, 0.6 and 0.8
27 Under the
optimum conditions,
developed method was found to be lin
28 Under the
optimum conditions,
enrichment factor of 11, 9, 9 and 10
29 Under
optimum conditions,
enrichment factors were in the range
30 e activated for homologous recombination; in
optimum conditions,
essentially 100% of the substrate re
31 This GO-based aptasensor under the
optimum conditions exhibited excellent analytical perfor
32 An
optimum condition exists at a cell-capillary tip distanc
33 Under
optimum conditions,
external calibration in solvent coul
34 The
optimum condition for the formation of PPy-XOD-Fc film i
35 ial measurements indicated that pH 5 was the
optimum condition for the highest protein extraction yie
36 e of this work was to develop a process with
optimum conditions for banana juice.
37 The
optimum conditions for catalysis consisted of 1 mM Mg(2+
38 ce centered design was used to establish the
optimum conditions for clarification of pomegranate juic
39 Optimum conditions for clarifying the AJ were chitosan c
40 in six edible oil samples were tested under
optimum conditions for DLLME, with a recovery ranging fr
41 The
optimum conditions for dye extraction were found to be 0
42 The
optimum conditions for electrode saturation were reached
43 Optimum conditions for extracting total phenolic compoun
44 Optimum conditions for glycan release were attained at r
45 not oxalic acid itself, that establishes the
optimum conditions for growth, reproduction, pathogenici
46 min) are required to operate the LB-DIHEN at
optimum conditions for ICPMS.
47 cal density of 10 at 605 nm was found as the
optimum conditions for immobilization with response time
48 tcomes for self-assembly ultimately provided
optimum conditions for isolation of either a molecular b
49 Optimum conditions for MAE were determined as 500W, 35%
50 Optimum conditions for OC and AC were 10 min steam blanc
51 Experiments to determine the
optimum conditions for perceiving illusory motion in Eng
52 The results showed that the
optimum conditions for pH, BA and TFA condition, type of
53 m albumen (BSA) and gultaraldehyde (GLA).The
optimum conditions for potentiometric bi-layer biosensor
54 The
optimum conditions for producing germinated Kodo millet
55 sing impedance measurements to determine the
optimum conditions for proliferation.
56 Optimum conditions for sample preparation are given alon
57 ta-protein fragment 1-16 (A beta(1-16)), the
optimum conditions for specific modification involve the
58 tested at varying concentrations to find the
optimum conditions for specific oxidation of only the am
59 The
optimum conditions for the assimilation reaction resembl
60 Using numerical optimization, the
optimum conditions for the enzymatic extraction of banan
61 increasing size of the alkali ion, reaching
optimum conditions for the largest cesium ion.
62 Optimum conditions for the oxidation of ethyl 1,3-dithia
63 entral-composite design was used to find the
optimum conditions for the preconcentration procedure th
64 ical texts are investigated to ascertain the
optimum conditions for the preparation of synthetic ultr
65 w/v) Triton X-100 and 15 mM MgCl(2) provided
optimum conditions for the stabilization of FPP.
66 Optimum conditions for toothed ponyfish muscle hydrolysi
67 Under
optimum conditions,
four separate mutations of the two c
68 Optimum conditions implicate the use of phenyl acrylates
69 synthesized as a result of germination under
optimum conditions in the Kodo millet depicted the germi
70 Optimum conditions included an increased formaldehyde co
71 Under
optimum condition,
it was found that the proposed method
72 Under the developed
optimum conditions,
limit of detection (LOD) for L. mono
73 Optimum conditions minimizing total spreading in a turn
74 The
optimum condition obtained was: sonication time 70min, t
75 At
optimum conditions obtained based on desirability functi
76 The
optimum conditions obtained were at column temperature o
77 experimental range of studied variables, the
optimum conditions of 54.03 degrees C and 148.16mbar wer
78 ytochemicals' activities were obtained under
optimum conditions of 7.81min blanching time and 9.24% b
79 Under
optimum conditions of ATPS, the purification of BLIS was
80 Under
optimum conditions of derivatization and microextraction
81 The
optimum conditions of derivatization are: 500muL of isop
82 The
optimum conditions of lycopene extraction were confirmed
83 The intensive
optimum conditions of MAE obtained at 80% EtOH, 50mL/g,
84 The
optimum conditions of MAE were as follows: X1=2.15min; X
85 FO for As(V) was found to be 22.1 mg/g under
optimum conditions of pH 4, contact time 3h and temperat
86 Depending on the extraction procedure, at
optimum conditions of steaming the results indicate that
87 AED method in the case of UAE, the intensive
optimum conditions of the extraction, i.e. 70% EtOH, 30m
88 AED of 250J/mL can be used to determine the
optimum conditions of the scale-dependent parameters i.e
89 Under
optimum conditions,
one aliquot of TAML 1a (400 nM) cata
90 n kinetic and equilibrium studies, under the
optimum condition (
pH = 2; amount of MIONPs = 87.15 mg;
91 Under
optimum conditions (
pH = 2; amount of damped MHAMS-MIONP
92 bosep Coregel 87H3 column was used under the
optimum conditions predicted: mobile phase of H2SO4 0.00
93 Under
optimum conditions,
solid samples were extracted with et
94 e easily monitored and regulated to maintain
optimum conditions that produce consistent yields of rAA
95 In the
optimum conditions the biofuel cell produced the power d
96 Under
optimum conditions the corresponding experimental values
97 Under
optimum conditions the present sensor exhibited high sen
98 At the
optimum conditions the sensor has a linear response in t
99 Under the
optimum condition,
the fluorescent intensity of the prob
100 In the
optimum condition,
the linear range of H2O2 determinatio
101 Under
optimum conditions,
the biomimetic sensor was employed f
102 Under
optimum conditions,
the boundary disappears, and the sta
103 Under
optimum conditions,
the calibration curves showed high l
104 Under the
optimum conditions,
the calibration graph was found to b
105 Under
optimum conditions,
the calibration graphs were linear i
106 Under
optimum conditions,
the current response is linear to it
107 Under the
optimum conditions,
the detection limit (3sigma) was 0.9
108 Under the
optimum conditions,
the detection limit was 0.6ngg(-1).
109 Under the
optimum conditions,
the detection limits (DL) of the met
110 Under
optimum conditions,
the detection limits were 0.02microg
111 Under
optimum conditions,
the enzymes produced polymers rangin
112 Results demonstrate that, under
optimum conditions,
the limit of detection of the immuno
113 Under the
optimum conditions,
the limits of detection and quantifi
114 Under
optimum conditions,
the linear range of the method was 0
115 At the
optimum conditions,
the norm of NAS vectors increased li
116 Under
optimum conditions,
the oxidation peak current enhanced
117 Under
optimum conditions,
the Pt/ZnO/AChE/Chitosan bio-electro
118 Under
optimum conditions,
the relative standard deviation, ads
119 Under
optimum conditions,
the results demonstrated that this e
120 Under the
optimum conditions,
the results have shown the order of
121 Under
optimum conditions,
the two approaches also give compara
122 ltrated with Single Bond (SB) adhesive under
optimum conditions;
the remaining, adjacent fraction was
123 h our experimental study, we have identified
optimum conditions to achieve high preconcentration rati
124 The
optimum conditions to obtain NCs were found to be 2.0 mg
125 validation experiments were conducted, under
optimum conditions,
to verify predictions and adequacy o
126 nce of reaction system hydrophobicity on the
optimum conditions using immobilised Candida antartica l
127 Under
optimum conditions,
UV-NTA-Fenton exhibited higher effic
128 In the case of CL corn starch, the
optimum condition was 70 degrees C and pH 12.
129 The
optimum condition was recorded at 3:2 DNA:MNP ratio, 1 H
130 The
optimum condition was: pH 8.43 and NaCl concentration 0.
131 The efficiency of extraction under these
optimum conditions was found to be 1133.86mg/L of phenol
132 Under
optimum conditions,
we achieved complete erythrocyte lys
133 The
optimum conditions were 1140microL of water, 125mg of Zn
134 The
optimum conditions were 1840muL of acetonitrile and 160m
135 The obtained
optimum conditions were applied to drinks.
136 The
optimum conditions were determined as HCl concentration
137 The
optimum conditions were determined as temperature of 59
138 Based upon this strategy,
optimum conditions were determined for investigating the
139 Optimum conditions were determined to be 40 degrees C an
140 clear apple juice (AJ) was investigated, the
optimum conditions were determined using RSM, and the ef
141 The
optimum conditions were found for the immobilization of
142 The
optimum conditions were found to be the use of a 4-fold
143 Optimum conditions were found using statistical optimiza
144 Optimum conditions were identified using the established
145 According to the presented results, the
optimum conditions were obtained when the sample was dil
146 ry of sterols were investigated to determine
optimum conditions which were tested for sterol extracti