ライフサイエンスコーパス: physisorption

1 ient gas separation and purification through physisorption.

2 , subsequently, very weak, near-zero energy, physisorption.

3 pectroscopy, XRD, FT-IR spectroscopy, and N2 physisorption.

4 of diffraction with electron microscopy and physisorption.

5 as interaction, in addition to van der Waals physisorption.

6 ipid, which bind to nanomaterials via robust physisorption.

7 to be the dominant contribution to hydrogen physisorption.

8 While physisorption allows one to assess micro- and mesopores,

9 namely synchrotron-based powder diffraction, physisorption analysis, and in-depth magnetic and therma

10 Combined with textural characterization from physisorption analysis, the data indicate that PEI first

11 N2 physisorption and base titration confirm the expected de

12 versibility of and relative contributions of physisorption and chemisorption to Hg(0) uptake would ch

13 uently used immobilization protocols such as physisorption and covalent bonding and detection techniq

14 r, there are two adsorption modes, molecular physisorption and dissociative chemisorption.

15 in tetrahydrofuran (THF) originate from the physisorption and organization of ODA along the SWNT sid

16 Data from N2 -physisorption and rotation electron diffraction provide

17 shown to be highly microporous, by using CO2 physisorption, and highly hydrophobic, possessing both B

18 let adsorption onto the foam was governed by physisorption, and the driving forces were attributed to

19 SEM/EDX, physisorption, and XRD analyses indicate that there is a

20 , IR (infrared) and adsorbate-IR, N2 and CO2 physisorption at 77 and 273 K, respectively, TPD-MS (tem

21 rization of reactivated material by nitrogen physisorption (BET, BJH) and scanning electron microscop

22 s while interacting with the film via a weak physisorption bond, making them ideal for vapor and gas

23 prepared, which shows a reversible hydrogen physisorption capacity of 0.6 and 3.2 wt % at 293 and 77

24 ificantly higher hydrogen binding energy and physisorption capacity, compared with the corresponding

25 een made, which led to major progress in the physisorption characterization methodology (summarized i

26 e we discuss progress and challenges for the physisorption characterization of nanoporous solids exhi

27 logy (summarized in the 2015 IUPAC report on physisorption characterization).

28 ingle and multiplex sensor arrays via direct physisorption, characterizing electrostatic effects on t

29 capsulation into sol-gel silica glass and by physisorption, chemisorption, and covalent attachment to

30 al surface silanols supplemented by nitrogen physisorption data and molecular dynamics simulations.

31 orous MOM with the smallest PLD suitable for physisorption, dia-7i-1-Co, was thereby found to exhibit

32 longer range, resulting in a stronger water physisorption (Ead > 0.2 eV) that is dominated by electr

33 N2 physisorption experiments indicated that, under some con

34 iew focuses on important aspects of applying physisorption for the pore structural characterization o

35 MP-2 and bFGF are readily loaded onto NDs by physisorption, forming a stable colloidal solution, and

36 aterials have been characterized by nitrogen physisorption, FTIR, NMR, and quantitative analysis of s

37 d theoretical and experimental study on H(2) physisorption in partially fluorinated graphite.

38 derstanding of the weak and elusive hydrogen physisorption interaction.

39 Physisorption is an effective route to meet hydrogen gas

40 Physisorption is seen between approximately -0.85 and 0

41 For water adsorption, only one mode, physisorption, is observed on the hydroxylated TiO(2) su

42 e neutron scattering (SANS), low-pressure N2 physisorption (LPNP), and mercury injection capillary pr

43 (M = Sb, In, Sn, Pb, Cd), determined by N 2 physisorption measurements, corresponds to high internal

44 on/scattering, combined with SEM imaging and physisorption measurements.

45 nalization has relied on lattice defects and physisorption methods that inevitably modify the topolog

46 This physisorption modifies the spin transition, producing a

47 oreover, additional counterion condensation (physisorption) occurs on the NT wall.

48 Physisorption of a cyclic peptide, Gramicidin S (GS), wa

49 Physisorption of BSA-Ac onto a fused-silica optical fibe

50 We investigated the effects of physisorption of gas molecule on the few-layer Mo:ReSe2

51 e layer so as not to significantly influence physisorption of molecules at the C-18/solution interfac

52 ergy released in low-energy chemisorption or physisorption of molecules on metal surfaces is usually

53 e to individual microelectrodes, followed by physisorption of neoglycoconjugates to the polypyrrole-c

54 oretical investigation, we conclude that the physisorption of NH3 molecule on Mo:ReSe2 monolayer can

55 to distinguish covalent bond formation from physisorption of proteins.

56 pen metal sites under dry conditions to weak physisorption of the analytes dissolved in surface-adsor

57 The reduction arises from physisorption of the neutral polymer, which turns the mo

58 contrast, control experiments involving the physisorption of the same analytes by conventional organ

59 ns to molecular systems constrained to 2D by physisorption on a conducting surface.

60 rvations of differences in the energetics of physisorption on ferroelectric domains are presented her

61 As a result, water physisorption on fully F-terminated surfaces is weak (ad

62 al discrimination between molecules bound by physisorption on the exterior surface of carbon single-w

63 facilitated chemisorption and the subsequent physisorption onto chemically adsorbed Hg.

64 ted peptide hbAP0 via both chemisorption and physisorption onto suitably alkylated solid substrates.

65 al characterization, formation processes and physisorption phenomena in these advanced materials are

66 the driving interaction for the endothermic physisorption process of organic vapor partitioning into

67 The physisorption results were further warranted by absorpti

68 tion of sorption yields benchmarking data on physisorption selectivity: response data and modeling re

69 fied nanoclays were characterised by XRD, N2-physisorption, SEM and FT-IR spectroscopy.

70 e fully characterized by solid-state NMR, N2 physisorption, SEM, and TGA in order to provide structur

71 ace diffusion, and the phase transition from physisorption to chemisorption, and we show that it pred

72 me, including alumina sol-gel encapsulation, physisorption to PDMS channels with, and without alumina

73 sorption process, although a small amount of physisorption was observed.

74 cycled materials were characterized using N2 physisorption, X-ray diffraction, and scanning and trans