戻る
「早戻しボタン」を押すと検索画面に戻ります。 [閉じる]

コーパス検索結果 (１語後でソート)

通し番号をクリックするとPubMedの該当ページを表示します
1 teral laminotomy, and 149 to spinous process osteotomy.
2 r, bilateral laminotomy, and spinous process osteotomy.
3 addition, the mice were subjected to a femur osteotomy.
4  on bony healing in a mouse model of femoral osteotomy.
5  greater than the volume required to fill an osteotomy.
6  12-week-old C57BL/6J mice underwent a femur osteotomy.
7 zone of dead and dying osteocytes around the osteotomy.
8  by muscle attachment to the lateral orbital osteotomy.
9 rwent a noncritical-sized transverse femoral osteotomy.
10 ion of the hip and periacetabular rotational osteotomy.
11 al nerve is damaged during preparation of an osteotomy.
12 reated by a specialized drill at the time of osteotomy.
13 me periods (D6, D10, D24, and D38) following osteotomy.
14 ical, (2) angled, (3) step, and (4) sagittal osteotomies.
15 ivalent between fresh extraction sockets and osteotomies.
16  than in CD and temperature variation during osteotomies.
17 advantages of the use of this laser for bone osteotomies.
18 ce gingival tissue or foreign materials into osteotomies?
19  were divided into three groups: (1) femoral osteotomy, (2) femoral osteotomy + stabilization with ex
20 l (no treatment); 2) a positive control (bur osteotomy); 3) CO2 laser at 5 W (860 J/cm2); 4) CO2 lase
21 tion regarding the effect of grafting of the osteotomy after subcrestal implant placement.
22  alone, corticotomy-assisted tooth movement, osteotomy alone, osteotomy-assisted tooth movement, or t
23                     Our study indicates that osteotomies and corticotomies induce different alveolar
24  indicated in the era of other redirectional osteotomies and if it can delay total hip arthroplasty (
25                                          The osteotomies and spring implantation were performed to si
26 options for symptomatic flatfeet may include osteotomies and/or fusions, but similarly high quality c
27 on, particulate bone graft was placed in the osteotomy and appropriately sized osteotomes were used f
28      Prior tumor resection with lateral wall osteotomy and failure to adhere to all protocol elements
29 rophied maxillae were treated with Le Fort I osteotomy and iliac bone grafting to allow for implant-b
30 tulous maxillae reconstructed with Le Fort I osteotomy and iliac bone grafting.
31 e loading of implants placed after Le Fort I osteotomy and interpositional iliac bone grafting could
32     Further, 12 op/op mice underwent femoral osteotomy and served as proof of concept.
33 lgesia in two mouse fracture models (femoral osteotomy) and could, therefore, serve as a potent alter
34 tral membrane, implants were placed into the osteotomies, and primary closure was executed at the sam
35            The implants were placed into the osteotomies, and the international stability quotient (I
36 generated during ultrasonic scaling, implant osteotomy, and restorative procedures by combining rever
37  animals and distraction osteogenesis in the osteotomy-assisted tooth movement animals.
38                     Corticotomy-assisted and osteotomy-assisted tooth movement involves surgical inci
39 my-assisted tooth movement, osteotomy alone, osteotomy-assisted tooth movement, or tooth movement alo
40       Bone cores were harvested from implant osteotomies at ~3 months after extraction for histomorph
41 ation when reducing the number of drills for osteotomy compared to the conventional drilling protocol
42 nd (ii) measurement of the torque during the osteotomies, comparing the new strategy with the convent
43                        The repair process of osteotomies created by the Er,Cr:YSGG laser, despite pro
44                         Implants placed into osteotomies created with PS and drills are similar in te
45 he animals were subjected to a 2-mm-diameter osteotomy created by conventional drills (drill group) o
46 the histologic healing of bone in rat tibial osteotomy defects created either by a dental bur, CO2 la
47 te long-term healing, from 21 to 63 days, of osteotomy defects in the rat tibia created with the Nd:Y
48                 Studies comparing healing of osteotomy defects prepared with rotary burs to those cre
49                                       Tibial osteotomy defects were created in 4 groups of 6 rats eac
50          In this animal model, laser-induced osteotomy defects, when compared to those prepared by ro
51      Prior tumor resection with lateral wall osteotomy, delay in IACC implementation or exenteration,
52 nderwent alveolar crest exposure and implant osteotomy followed by MIAMBE (> 10 mm).
53 m plate stress was highest with the vertical osteotomy, followed by the angled osteotomy (median diff
54       Bone cores were retrieved from implant osteotomies for histologic analysis.
55 th of the implant in the coronal half of the osteotomy for cement placement.
56 ts of 9 patients underwent radial shortening osteotomy for Kienbock's disease.
57 ist joint before and after radial shortening osteotomy for Kienbock's disease.
58 ies of patients who underwent Periacetabular Osteotomy for symptomatic hip dysplasia was completed.
59 were generated from 59 CT scans (33 operated osteotomy fractures, 26 contralateral intact bones).
60 he sagittal plane for 15 minutes/day) of the osteotomy gap beginning on day 10 after the operation.
61 ical studies analyzing the impact of varying osteotomy geometries are warranted to translate these fi
62 CI, -22.7 to -16.8), and the spinous process osteotomy group had a mean change of -19.9 ODI points (9
63  and 2 patients were combined with Le Fort I osteotomy guided by digital templates.
64                       In vitro, the vertical osteotomy had the highest maximum strain, followed by th
65                                    An angled osteotomy had the lowest stress at 30 degrees of angulat
66 be speculated that PS and conventional drill osteotomy have similar effects on peri-implant tissues o
67 hese analytical tools with in vivo models of osteotomy healing and implant osseointegration to determ
68 ed in bone healing with implants, but not in osteotomy healing.
69 ontralateral critical-size 6 mm rat calvaria osteotomies in 18 animals.
70 y available drills were then used to produce osteotomies in a patient cohort and in the rat model.
71 MP-2 was delivered to critical-sized femoral osteotomies in rats.
72 well-delimited and smooth walls, whereas the osteotomies in the laser group were irregular and presen
73            The mean of the DeltaT during the osteotomies in type III bone was: 6.8 +/- 1.26 degrees C
74 used to measure the torque value during each osteotomy in both synthetic bone density blocks.
75 rios compared with angled, step, or sagittal osteotomies, in silico and in vitro.
76                          The disadvantage of osteotomy is a relatively long-term recovery time and lo
77                           The Periacetabular Osteotomy is a technically demanding procedure that requ
78  osteotomy were evaluated to confirm if this osteotomy is indicated in the era of other redirectional
79  to the sinus floor, apical extension of the osteotomy is significantly limited, and often a staged a
80                        Steel's triple pelvic osteotomy is still indicated as a safe and effective tec
81  the surgical outcome: for each patient, the osteotomy location was varied in a pre-defined range; lo
82                                The segmental osteotomy may provide an alternative treatment to the re
83 ding, 0 mV/V; 95% CI, -0.004 to 0.005), step osteotomy (mean difference vs angled: incisal loading, 0
84 021 mV/V; 95% CI, 0.016-0.027), and sagittal osteotomy (mean difference vs step: incisal loading, 0.0
85 ghest maximum strain, followed by the angled osteotomy (mean difference vs vertical: incisal loading,
86 molar loading, 91 MPa; 95% CI, 23-189), step osteotomy (median difference vs angled: ipsilateral mola
87 ding, -17; 95% CI, -115 to 83), and sagittal osteotomy (median difference vs step: ipsilateral molar
88 e vertical osteotomy, followed by the angled osteotomy (median difference vs vertical: ipsilateral mo
89                 CBL values did not depend on osteotomy modality (P > 0.05).
90 is process, we developed a standardized oral osteotomy model in ovariectomized rats.
91            The treatment study using a mouse osteotomy model validated the micelles' therapeutic effi
92 n, reconstruction, size of defect, number of osteotomies needed, and complications.
93 of the abnormal cartilages, transverse wedge osteotomy of the anterior sternum, and internal support
94         The second step involved anti-valgus osteotomy of the right tibial bone.
95 domly implanting respective bone matrices in osteotomies on femurs for 14 and 28 days and evaluated b
96          In symptomatic children, orthotics, osteotomies, or fusions may be considered.
97 ctional deficits may benefit from orthotics, osteotomies, or fusions.
98 ts exist concerning healing of laser created osteotomies over an extended period of time.
99  ascertain whether opening-wedge high-tibial osteotomy (OW-HTO) corrected pathomechanical abnormaliti
100                              We suggest that osteotomy plane 1.5 cm beyond the T1 tumour margin is sa
101                                  After ideal osteotomy preparation, particulate bone graft was placed
102 dimensional changes compared to SD following osteotomy preparation, predictably maintains BBT and red
103 sing a trephine drill during initial implant osteotomy preparation.
104 dure, atraumatic extractions were completed, osteotomies prepared in the ideal orientation, and impla
105 ceptor (AR) blocker propranolol before femur osteotomy prevented bone marrow mobilization of neutroph
106                                  A segmental osteotomy procedure was used to reposition the implants.
107 ts a case report and review of the segmental osteotomy procedure.
108 is a strategically important landmark during osteotomy procedures.
109                                The segmental osteotomy provides an important treatment approach for t
110 ect class relates to the size of the defect, osteotomy rate, and functional and aesthetic outcome, an
111      In this study, the traditional vertical osteotomy resulted in less favorable plate stresses in a
112                            Preparation of an osteotomy results in a narrow zone of dead and dying ost
113 A bone core was taken in the planned implant osteotomy site and evaluated histomorphometrically to de
114 bone remodeling rates, mitotic activity, and osteotomy site healing in type III bone and high endogen
115 rm objective is to devise methods to improve osteotomy site preparation and, in doing so, facilitate
116 sponses of human and rodent alveolar bone to osteotomy site preparation.
117  insights into the response of human bone to osteotomy site preparation.
118 ch tooth replacement would result in a final osteotomy site that would compromise the overall thickne
119 ing the zone of osteocyte death will improve osteotomy site viability, leading to faster new bone for
120 on was utilized to prepare the final implant osteotomy site.
121 e week after surgery, extraction sockets and osteotomy sites exhibited similar patterns of new bone d
122 PISF) during healing and osseointegration at osteotomy sites prepared either with piezosurgery (PS) o
123                                      Implant osteotomy sites were prepared and standardized 3-walled
124 lantation of AAV-bound allograft bone to the osteotomy sites.
125 umber of patients, age, gender, surgeon, and osteotomy size were comparable among groups (p = 0.4-0.9
126 zation with external fixator and (3) femoral osteotomy + stabilization with external fixator + system
127 e groups: (1) femoral osteotomy, (2) femoral osteotomy + stabilization with external fixator and (3)
128 d be collected at multiple time points after osteotomy, the fate of the dead alveolar bone was follow
129      For the gingivectomy as well as for the osteotomy, the mean discrepancy was increased in the pre
130 positioned intra-bone (1 mm distant from the osteotomy) to measure the temperature produced.
131 n two types of implant sites for example, an osteotomy versus a fresh extraction socket were compared
132  were inserted with full contact between the osteotomy walls and the implant surface.
133  between the residual implant length and the osteotomy walls.
134                The maximum torque during the osteotomies was: 8.8 +/- 0.97 Ncm for CD samples and 11.
135 -CSF application in a mouse model of femoral osteotomy was oppositional to what we were expecting.
136                                          The osteotomy was performed using 2 surgical guide designs.
137                A transverse anterior sternal osteotomy was used on most patients.
138                                              Osteotomies were created in healed maxillary extraction
139                                       Twenty osteotomies were made for each subgroup with a thermocou
140                                In total, 317 osteotomies were performed on 225 women and 58 men betwe
141                                A total of 80 osteotomies were prepared in dense bone samples (quality
142 n the posterior maxilla were enrolled and 38 osteotomies were prepared.
143 r premolar teeth were extracted; the implant osteotomies were prepared; and a uniform circumferential
144 he oral cavity; 12 weeks later, in phase II, osteotomies were produced in healed extraction sites, an
145                                      Second, osteotomies were produced in healed tooth extraction sit
146 rm results of modified Steel's triple pelvic osteotomy were evaluated to confirm if this osteotomy is
147 ro-computed tomography on the first-day post osteotomy, which, combined with detailed finite element
148                                          The osteotomy with the drill produced well-delimited and smo

 
Page Top